Microsens RS232 Spécifications télécharger pdf (Page 20)

19'' 6U Chassis page 20/71

...\microsens\moduleMS430601M\ms430601mcontrolsWrite\ms430601mCtrlLine\

ms430601mCtrllineSfpOnOffCtrlTable\

• Remove the Fibre Optic connector

• Release the SFP by: Carefully opening the latch or pressing the locking

button and slide the SFP out of the module and place it aside

• Gently push the SFP into the relevant module port until it is securely seated.

Take care to insert the SFP respecting the orientation described in the

following picture

Do not remove the protective caps from the SFP until you are ready to attach

the fibre-optic.

• Clean Fibre Optic connectors on fibre optic cable

• Re-connect Fibre

• Verify correct operation of the SFP

End procedure

XFP Replacement Procedure

The Line port has two LEDs located on the front panel of the MS; LOS and Fail,

indicating operating status of each of the ports. If a Line port XFP needs to be replaced

use the following procedure:

Procedure

The following procedure describes how replacing an XFP on a MS43062XM.

The XFP ’s are hot-swappable therefore there is no requirement to power down the

Module.

• Ensure that the correct module is selected for management. Consult the

object:

mgnt2GigmSelectedBoard

Location:

..\microsens\mgnt2\mgnt2SNMPAgentData\mgnt2ModulesManagement\

• Change if necessary

• Refresh the module inventory setting the following object:

ms43062XMRinvReloadInventory

Location: ...\microsens\moduleMS43062XM\ms43062XMri\

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 70 71

Pas de commentaire

Microsens RS232 Spécifications Page 20