Microsens RS232 Spécifications télécharger pdf (Page 12)

4 Port Industrial Device Server Manual page 12/36

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

Network Setting

Device Server can connect the Network by wire a. You must assign a valid IP

address for the device before attached in your network environment. Your network

administrator should provide you the IP address and related settings. The IP

address must be unique within the network (otherwise, device will not have a valid

connection to the network). You can choose from three possible “IP

configuration” modes: Static, DHCP/BOOTP. The Factory Default IP address is

“192.168.16.1”

The following table describes the labels in this screen.

Label

Description

Using DHCP/BOOTP

IP Address automatically assigned by a DHCP server in your network.

Static IP Address

Manually assigning an IP address.

Subnet Mask

All devices on the network must have the same subnet mask to

communicate on the network.

Gateway

Enter the IP address of the router in you network.

DNS Server

Enter the IP address of the DNS server, The DNS server translates

domain names into IP address.

Switch Mode

Redundant:

When the connection between master-link and LAN fails, the Device

Server can automatically switch to another LAN port within10ms, and

still guarantees a non-stop connection

Switch:

Daisy Chain support to reduce usage of switch ports.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Pas de commentaire

Microsens RS232 Spécifications Page 12